What clutch bell can you use on the Werks pro 4 clutch system?
I run losi vehicles im looking at going werks and ditching the losi clutch.
Does the losi clutch bell fit?
Werks Clutch
You will have to run the 2 piece engine mount on the losi so you can run it with the engine in the forward position and then pretty much most bell types other than the losi type....they are specific to the losi cars
WERKS RACING NZ
HB Racing D817 Werks B7KE
HB Racing D817T Werks B3 Proll
Werks Race Blend Fuel
HB Racing D817 Werks B7KE
HB Racing D817T Werks B3 Proll
Werks Race Blend Fuel
Cheers for that.
Im already running the losi quick change engine mounts on both buggy and truggy so that's good.
Any suppliers out there sell 12t clutch bells that aren't losi type?
Im already running the losi quick change engine mounts on both buggy and truggy so that's good.
Any suppliers out there sell 12t clutch bells that aren't losi type?
Losi 8ight-T 3.0 Werks b5 pro
Losi 8ight 3.0 Argus R8
Losi 8ight-E 2.0 Tekin
Losi Ten-Scte Tekin
Losi 8ight 3.0 Argus R8
Losi 8ight-E 2.0 Tekin
Losi Ten-Scte Tekin
Next question about this clutch setup on a losi is whether you use the losi clutch collet and nut or the werks collet and nut? Im trying a 2nd hand unit that wasn't on a losi before.
Losi 8ight-T 3.0 Werks b5 pro
Losi 8ight 3.0 Argus R8
Losi 8ight-E 2.0 Tekin
Losi Ten-Scte Tekin
Losi 8ight 3.0 Argus R8
Losi 8ight-E 2.0 Tekin
Losi Ten-Scte Tekin
You should always use the collet that comes with the flywheel as different makes have different tapers etc,......the nut not as crucial but if there is a signicant difference in length and it requires a heap of thrust washers to get bell to flywheel clearance the try another nut 

WERKS RACING NZ
HB Racing D817 Werks B7KE
HB Racing D817T Werks B3 Proll
Werks Race Blend Fuel
HB Racing D817 Werks B7KE
HB Racing D817T Werks B3 Proll
Werks Race Blend Fuel
-
- Information
-
Who is online
Users browsing this forum: No registered users and 5 guests